Smaller photographs may be submitted provided they are sharp and clear, show the necessary detail, and are mounted on A4 (21 cm × 29.7 cm) or 8.5 × 11 inch (21.6 cm × 27.9 cm) paper. Photographs shall be of size A4 (21 cm × 29.7 cm) or 8 × 10 inches (20.3 cm × 25.4 cm). In lieu of a photograph of the label, a sample label (or facsimile thereof) may be submitted together with a sketch showing where this label will be placed on the equipment. The exterior views shall show the overall appearance, the antenna used with the device (if any), the controls available to the user, and the required identification label in sufficient detail so that the name and FCC identifier can be read. (7) A sufficient number of photographs to clearly show the exterior appearance, the construction, the component placement on the chassis, and the chassis assembly.
The report shall include sample calculations showing how the measurement results were converted for comparison with the technical requirements. This report shall identify the test procedure used (e.g., specify the FCC test procedure, or industry test procedure that was used), the date the measurements were made, the location where the measurements were made, and the device that was tested (model and serial number, if available). (6) A report of measurements showing compliance with the pertinent FCC technical requirements. A schematic diagram is also required for intentional radiators. The tuning range(s) and intermediate frequency(ies) shall be indicated at each block. The signal path and frequency shall be indicated at each block. (5) A block diagram showing the frequency of all oscillators in the device. This statement should contain a description of the ground system and antenna, if any, used with the device. (4) A brief description of the circuit functions of the device along with a statement describing how the device operates. The actual document shall be furnished to the FCC when it becomes available. A draft copy of the instructions may be submitted if the actual document is not available. (3) A copy of the installation and operating instructions to be furnished the user.
FCC ID SERIAL NUMBER FULL
(1) The full name and mailing address of the manufacturer of the device and the applicant for certification. (b) Applications for equipment operating under Parts 11, 15 and 18 of the rules shall be accompanied by a technical report containing the following information: Items that do not apply shall be so noted. (a) An application for certification shall be filed on FCC Form 731 with all questions answered.